Haweka Pro Balancing System greatly increases wheel balancing accuracy by increasing the accuracy of the wheel mounting. Also allows the mounting of most CLAD WHEELS (plastic faced). This item is for 40mm balancer shaft. Kits are available for other diameter shafts. Please confirm your balancer shaft size before ordering.
The Low-Taper Collets are superior to standard cones because they have more contact area and engage the wheel at a better angle; they are also necessary for Clad Wheels because they are shorter and only contact the metal part of the wheel. They can be used for "standard" wheels as a replacement for the cones. -- The collets in this kit must always be used on the back of the wheel and never from the front. Wheels cannot be balanced properly using collets from the front.
The Flange Plates provide superior Lug-Centric mounting and allow mounting custom, expensive, and clad wheels with no contact on the face of the wheel for even pressure and full hub centering contact in the wheel hub.
FREE SHIPPING
Features Include
WHAT IS NEEDED TO BALANCE THE NEW CLAD WHEELS?
COLLETS instead of cones for the inside center hole. Standard cones will often contact the plastic part inside the hole.
A LUG-CENTRIC PRESSURE DEVICE for centering and clamping the front of the wheel without contacting the "face".
A WHEEL BALANCER WITH A LONG ENOUGH SHAFT. The standard shaft on some older wheel balancers may not be long enough to accommodate this mounting system. It varies, but a good rule-of-thumb is if the threaded part of the shaft extends to about 8" from the balancer hub-plate.
